Xbee MAC Interface SAM4S

Source code, setting up explanations, and everything moved to:

https://github.com/rromanotero/xbee_mac_interface

.

By |2019-05-31T08:07:08+00:00June 30th, 2015|Middleware, SAM4S Xpro, Xbee|1 Comment

One Comment

  1. kiran December 5, 2017 at 8:46 am - Reply

    AM USING XBE PRO S1 WITH ATMEL sam4s4a MCU TO TEST AT COMMAND.FIRMWARE IS 8073 FOR PDT FAMILY XBP24-DM FUNCTION SET :XBEE PRO DIGIMESH2.4. AM UNABLE TO GET OK RESPONSE FOR +++

    HARDWARE CONFIG:
    VCC TO MCU 3.3 & GND TO GND
    TX TO MCU RX
    RX TO MCU TX

    SOFTWARE:

    1)INIT UART IN MCU:bAUDRATE 9600 ,8 BITS,1 STOP BIT NO PARITY …SAME FOR XBEE

    2)1 SEC GUARD TIME

    3)+++ (WITHOUT \n OR”)

    4)1 SEC GUARD TIME DELAY

    5)WAITING FOR OK RESPONSE..BUT I DONT GET IT ..CHECKED IN OSCILLOSCOPE FOR TRANSMITTING FROM MCU TO XBEE RX BUT NO OK REPLY BACK FROM XBEE..

    ********************

    TRIED TO SEND 12345 TO ANOTHER XBEE MODULE CONNECTED TO PC VIA XCTU WITH SAME CONFIG BUT I RECEIVE IT AS 124

    **********************

    proceeding to test above code have ported the code for sam4s4a with UART1 (not usart1). i want to test any at command..how do i do using above code..will get stuck at xbee_send_at_command( (uint8_t*)”BD”, (uint8_t*)””, 0 );

Leave A Comment Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.